Customer Service: +0086-755-21613334


Your shopping cart is empty!

1.25g csfp transceiver is short for 1.25g Compact small form-factor pluggable transceiver.The Compact SFP (CSFP) transceiver is a Gigabit Ethernet transceiver with two bidirectional channels inside a conventional SFP form factor.CSFP transceiver and a compact small form-factor CSFF transceiver supports network systems, especially those deploying single-fiber bidirectional transceivers in high density applications. The CSFP MSA defines a transceiver mechanical form-factor with latching mechanism and a host board, SFP-like, electrical edge connector and cage. The CSFF MSA also defines a transceiver mechanical form-factor. The dual-channel CSFP has the same mechanical dimensions as the industry-standard SFP transceiver and is compatible with the standard SFP cage. The single-channel CSFP and CSFF are half the size of the industry-standard SFP and SFF packages. The CSFP design is modular to enable configurations of integrated 2ch modules. In future Cozlink will develop 4ch CSFP modules. These highly integrated compact transceiver modules will enable network system vendors to increase port density and data throughput, while reducing network equipment cost.

Compact-SFP is a new kind of fiber transceiver usually known as CSFP fiber optic transceivers.CSFP has the same size of SFP, Cisco also called this as 2- channel bi-directional SFP. The Cozlink 2-channel 1000BASE-BX-D SFP module, also known as Compact BIDI SFP, integrates two Bi-directional interfaces in one SFP module. The Compact SFP is always connected to two 1000BASE-BX10-U interfaces over two single strands of standard SMF with an operating transmission range up to 20km.

The CSFP transceiver consists of 2-channel Bi-directional transceiver unit with five sections: the LD driver, the limiting amplifier, the digital diagnostic monitor, the 1310nm DFB laser and the 1490nm PIN photo-detector. The optical output can be disabled by a TTL logic high-level input of Tx Disable, and the system also can disable the module via I2C. Tx Fault is provided to indicate that degradation of the laser. Loss of signal (LOS) output is provided to indicate the loss of an input optical signal of receiver or the link status with partner. The system can also get the LOS (or Link)/Disable/Fault information via I2C register access. Conventional SFP will function when plugged into a C-SFP socket, at the same time no damage to C-SFP and host board if C-SFP module is plugged into a conventional SFP socket.

Our csfp optical transceiver can be well compatible with Cisco gigabit compact sfp,that is csfp transceiver.

Besides,we can also supply CFP 40G 10km modules.

1.25G CSFP Transceivers ( 3 results )

Filter by:
Distance: 10km 20km
Interface: LC
Fiber Mode: Single-Mode
Copyright © 2016 All Rights Reserved.